F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

113
410BConfiguring a broadcast client
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
This command enters the view of
the interface for sending NTP
broadcast messages.
3. Configure the device to
operate in NTP broadcast
client mode.
ntp-service broadcast-client N/A
411BConfiguring the broadcast server
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
This command enters the view of
the interface for sending NTP
broadcast messages.
3. Configure the device to
operate in NTP broadcast
server mode.
ntp-service broadcast-server
[ authentication-keyid keyid |
version number ] *
A broadcast server can
synchronize broadcast clients only
when its clock has been
synchronized.
239BConfiguring NTP multicast mode
The multicast server periodically sends NTP multicast messages to multicast clients, which send replies
after receiving the messages and synchronize their local clocks.
Configure the NTP multicast mode on both the server and clients. The NTP multicast mode must be
configured in a specific interface view.
412BConfiguring a multicast client
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
This command enters the view of
the interface for sending NTP
multicast messages.
3. Configure the device to
operate in NTP multicast client
mode.
ntp-service multicast-client
[ ip-address ]
You can configure up to 1024
multicast clients, of which 128 can
take effect at the same time.
413BConfiguring the multicast server
Ste
p
Command Remarks
1. Enter system view.
system-view N/A