F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

167
Ste
p
Command Remarks
2. Enable the SSH server to
support SSH1 clients.
ssh server compatible-ssh1x
enable
Optional.
By default, the SSH server supports
SSH1 clients.
3. Set the RSA server key pair
update interval.
ssh server rekey-interval hours
Optional.
By default, the interval is 0, and the
RSA server key pair is not updated.
4. Set the SSH user
authentication timeout period.
ssh server authentication-timeout
time-out-value
Optional.
60 seconds by default.
5. Set the maximum number of
SSH authentication attempts.
ssh server authentication-retries
times
Optional.
3 by default.
Authentication fails if the number of
authentication attempts (including
both publickey and password
authentication) exceeds the upper
limit.
6. Configure the SFTP
connection idle timeout
period.
sftp server idle-timeout
time-out-value
Optional.
10 minutes by default.
102B
Configuring the device as an Stelnet client
This section describes how to configure the device as an Stelnet client.
281BStelnet client configuration task list
Task Remarks
881H
Specifying a source IP address or source interface for the Stelnet client Optional.
882H
Enabling and disabling first-time authentication Optional.
883H
Establishing a connection to an Stelnet server Required.
282BSpecifying a source IP address or source interface for the
Stelnet client
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes