F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

171
Task Remarks
890H
Displaying help information Optional.
891H
Terminating the connection with the SFTP server Optional.
286BSpecifying a source IP address or source interface for the SFTP
client
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes
U200-S No
By default, an SFTP client uses the IP address of the outbound interface specified by the route to the SFTP
server as the source IP address to communicate with the SFTP server. You can change the source IP
address or specify a source interface for the client.
To make sure the SFTP client and the SFTP server can communicate with each other, and to improve the
manageability of SFTP clients in the authentication service, HP recommends that you specify a loopback
interface or dialer interface as the source interface.
To specify a source IP address or interface for the SFTP client:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Specify a source IP
address or interface for
the SFTP client.
• Specify a source IPv4 address or interface
for the SFTP client:
sftp client source { interface interface-type
interface-number | ip ip-address }
• Specify a source IPv6 address or interface
for the SFTP client:
sftp client ipv6 source { interface
interface-type interface-number | ipv6
ipv6-address }
Use either command.
NOTE:
Support for the sftp client ipv6
source command depends on
the device model.
287BEstablishing a connection to an SFTP server
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI Yes