F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

188
# Specify the authentication method for user client002 as publickey, and assign the public key
ClientKey to the user.
[Router] ssh user client002 service-type stelnet authentication-type publickey assign
publickey ClientKey
3. Establish a connection to the Stelnet server:
# Establish an SSH connection to the Stelnet server 192.168.1.40.
<Firewall> ssh2 192.168.1.40
Username: client002
Trying 192.168.1.40 ...
Press CTRL+K to abort
Connected to 192.168.1.40 ...
The Server is not authenticated. Continue? [Y/N]:y
Do you want to save the server public key? [Y/N]:n
Then, you can log in to the router successfully.
107B
SFTP configuration examples
298BWhen the firewall acts as an SFTP server for password
authentication
470BNetwork requirements
As shown in 903HFigure 83, you can log in to the firewall through the SFTP client that runs on the host. The
firewall acts as the SFTP server and uses password authentication. The username and password of the
client are saved on the firewall.
Figure 83 Network diagram
471BConfiguration procedure
1. Configure the SFTP server:
# Generate the RSA key pairs.
<Firewall> system-view
[Firewall] public-key local create rsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++
++++++++++++++