F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

228
• 35 3637 38 corresponds to the password 5678.
• 20 is the end delimiter.
For more information about DHCP, DHCP Option 43, and the option command, see Network
Management Configuration Guide.
333BConfiguring CWMP at the CLI
Some tasks in this section can also be performed on the ACS or DHCP server. For a CWMP parameter,
the setting assigned by the ACS has the same priority as the CLI setting, and the setting issued by the
DHCP server has lower priority than the CLI setting. The ACS-assigned setting and the CLI setting override
each other, and whichever is configured the last takes effect.
Complete the following tasks to configure CWMP at the CLI:
Task Remarks
933H
Enabling CWMP Required.
Configuring ACS attributes:
• 934HConfiguring the ACS URL
Required.
Supports configuration through ACS,
DHCP, and CLI.
• 935HConfiguring the ACS username and password
Optional.
Supports configuration through ACS,
DHCP, and CLI.
Configuring CPE attributes:
• 936HConfiguring the CPE username and password
Optional.
Supports configuration through ACS and
CLI.
• 937HConfiguring the CWMP connection interface
Optional.
Supports configuration through CLI only.
• 938HSending Inform messages
Optional.
Supports configuration through ACS and
CLI.
• 939HConfiguring the maximum number of attempts made to retry a
connection
Optional.
Supports configuration through CLI only.
• 940HConfiguring the close-wait timer of the CPE
Optional.
Supports configuration through CLI only.
• 941HConfiguring the CPE working mode
Optional.
Supports configuration through CLI only.
• 942HSpecifying an SSL client policy for HTTPS connection to ACS
Optional.
Supports configuration through CLI only.
123B
Enabling CWMP
CWMP configurations can take effect only after you enable CWMP.