F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

229
To enable CWMP:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view. cwmp N/A
3. Enable CWMP.
cwmp enable By default, CWMP is enabled.
124B
Configuring ACS attributes
ACS attributes include ACS URL, username and password. When the CPE initiates a connection to the
ACS, the ACS URL, username and password are carried in the connection request. After the ACS receives
the request, if the parameter values in the request are consistent with those configured locally, the
authentication succeeds, and the connection is allowed to be established. If not, the authentication fails,
and the connection is not allowed to be established.
334BConfiguring the ACS URL
You can assign only one ACS for a CPE and the ACS URL you configured overwrites the old one, if any.
To configure the ACS URL:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter CWMP view.
cwmp N/A
3. Configure the ACS URL. cwmp acs url url
By default, no ACS URL is
configured.
335BConfiguring the ACS username and password
To pass ACS authentication, make sure that the configured username and password are the same as
those configured for the CPE on the ACS.
To configure the ACS username and password:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter CWMP view.
cwmp N/A
3. Configure the ACS username
for connection to the ACS.
cwmp acs username username
By default, no ACS username is
configured for connection to the
ACS.