F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

43
372BStopping running patches
When you stop running a patch, the patch state becomes DEACTIVE, and the system runs the way it did
before it was installed with the patch.
To stop running patches:
Ste
p
Command
1. Enter system view.
system-view
2. Stop running patches.
patch deactive [ patch-number ]
373BRemoving patches from the patch memory area
After being removed from the patch memory area, a patch is still retained in IDLE state in the storage
medium. The system runs the way it did before it was installed with the patch.
HP recommends that you uninstall all patches by using the undo patch install command.
To remove patches from the patch memory area:
Ste
p
Command
1. Enter system view.
system-view
2. Remove patches from the patch memory area. patch delete [ patch-number ]
47B
Displaying and maintaining software upgrade
Task Command Remarks
Display information about the
system software image.
display boot-loader [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Display information about the
patch package.
display patch [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display the patch information.
display patch information [ | { begin |
exclude | include } regular-expression ]
Available in any view.
48B
Software upgrade examples
183BUpgrading the entire system software from the CLI
374BNetwork requirement
The current system software version is soft-version1 for the firewall in 746HFigure 19. The latest system software
image soft-version2.bin and the latest configuration file new-config.cfg are both saved in cfa0:/aaa on
the FTP server. The firewall and the FTP server can reach each other, and the PC and the firewall can
reach each other.
Upgrade the software version of the firewall to soft-version2 and configuration file to new-config.