F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

67
Ste
p
Command Remarks
8. Enable system information
output to the monitor terminal.
terminal monitor
The default setting is disabled.
You must execute this command
before you can enable the display
of debugging, log, and trap
information on the monitor
terminal.
9. Enable the display of system
information on the monitor
terminal.
• Enable the display of debug
information on the monitor
terminal:
terminal debugging
• Enable the display of log
information on the monitor
terminal:
terminal logging
• Enable the display of trap
information on the monitor
terminal:
terminal trapping
Optional.
By default, the monitor terminal
displays log and trap information,
and discards debug information.
57B
Outputting system information to a log host
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the information
center.
info-center enable
Optional.
Enabled by default.
3. Specify a name for a
channel identified by its
number.
info-center channel channel-number
name channel-name
Optional.
See
779H
Table 8 for default channel names.
4. Configure an output rule
for the log host.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
Optional.
See "
780H
Default output rules of system
information."
5. Specify the source IP
address for the log
information.
info-center loghost source
interface-type interface-number
Optional.
By default, the source IP address of
output log information is the primary IP
address of the matching route' egress
interface.
6. Configure the timestamp
format for system
information output to the
log host.
info-center timestamp loghost { date
| iso | no-year-date | none }
Optional.
date by default.