F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

68
Ste
p
Command Remarks
7. Set the system
information format.
• Set the format to unicom:
info-center format unicom
• Set the format to china-telecom:
info-center format
china-telecom
• Set the format to
china-unicom-nat444:
info-center format
china-unicom-nat444
• Set the format to HP:
undo info-center format
Optional.
Use any approach.
HP by default.
The china-telnetcom and
china-unicom-nat444 formats are
available only for NAT444. For more
information about NAT444, see NAT
and ALG Configuration Guide.
8. Specify a log host and
configure related
parameters.
info-center loghost [ vpn-instance
vpn-instance-name ]
{ host-ipv4-address | ipv6
host-ipv6-address } [ port
port-number ] [ channel
{ channel-number | channel-name }
| facility local-number ] *
By default, no log host or related
parameters are specified.
If no channel is specified when
outputting system information to a log
host, the system uses channel 2
(loghost) by default.
The value of the port-number argument
must be the same as the value
configured on the log host. Otherwise,
the log host cannot receive system
information.
Support for the ipv6 host-ipv6-address
option depends on the device model.
For more information, see Access
Control Command Reference.
The following matrix shows the feature and hardware compatibility:
Hardware
Outputting system information in
china-telecom or china-unicom-nat444 format
to the lo
g
host
F1000-A-EI/F1000-S-EI No
F1000-E Yes
F5000 No
Firewall module Yes
U200-A No
U200-S No
58B
Outputting system information to the trap buffer
The trap buffer only receives trap information, and discards log and debug information.
To output system information to the trap buffer:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A