F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Configuration Guide-6PW100

71
61B
Outputting system information to the Web interface
The Web interface only receives log information, and discards trap and debug information.
This feature allows you to control whether to output system information to the Web interface and, if so,
which system information can be output to the Web interface. The Web interface provides abundant
search and sorting functions. If you output system information to the Web interface, you can view the
system information by clicking corresponding tabs after logging in to the device through the Web
interface.
To output system information to the Web interface:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center.
info-center enable
Optional.
Enabled by default.
3. Specify a name for a channel
identified by its number.
info-center channel
channel-number name
channel-name
Optional.
See
787H
Table 8 for default channel
names.
4. Configure an output channel
for the Web interface.
info-center syslog channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the Web interface
through channel 6.
5. Configure an output rule for
the Web interface.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state }* | log { level
severity | state state }* | trap
{ level severity | state state }* ]*
Optional.
See "
788H
Default output rules of system
information."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The timestamp format for log, trap
and debug information is date by
default.
62B
Saving system information to a log file
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A No
U200-S No