F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Command Reference-6PW100

Hardware i

v6-address

F1000-A-EI/F1000-S-EI Yes

F1000-E Yes

F5000 Yes

Firewall module Yes

U200-A Yes

U200-S No

interface-type interface-number: Specifies the source interface type and number.

Usage guidelines

The tunnel source address is the address of the interface sending packets and should be configured as

the destination address of the peer tunnel interface.

Automatic tunnel interfaces using the same encapsulation protocol must have different source addresses.

Manual tunnel interfaces using the same encapsulation protocol must have different source and

destination addresses.

Examples

# Set the tunnel source address to 192.100.1.1 on the interface Tunnel 5.

<Sysname> system-view

[Sysname] interface tunnel 5

[Sysname-Tunnel5] source 192.100.1.1

Or set the tunnel source interface to GigabitEthernet 0/1.

<Sysname> system-view

[Sysname] interface tunnel 5

[Sysname-Tunnel5] source gigabitethernet 0/1

Related commands

• destination

• interface tunnel

• display interface tunnel

• display ipv6 interface tunnel

tunnel bandwidth

Use tunnel bandwidth to set the bandwidth of a tunnel interface.

Use undo tunnel bandwidth to restore the default.

Syntax

tunnel bandwidth bandwidth-value

undo tunnel bandwidth

Default

The bandwidth of the tunnel interface is 64 kbps.