F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Command Reference-6PW100

79
Table 20 Command output
Field Descri
p
tion
connection id Connection ID, used to uniquely identify an IPsec Tunnel.
status
Whether the tunnel is in the active or standby state.
This field is displayed only when IPsec stateful failover is enabled.
perfect forward secrecy
Perfect forward secrecy, indicating which DH group is to be used for fast
negotiation mode in IKE phase 2.
SA's SPI SPIs of the inbound and outbound SAs.
tunnel Local and remote addresses of the tunnel.
flow
Data flow protected by the IPsec tunnel, including source IP address,
destination IP address, source port, destination port and protocol.
as defined in acl 3001 The IPsec tunnel protects all data flows defined by ACL 3001.
encapsulation-mode
Use encapsulation-mode to set the encapsulation mode that the security protocol uses to encapsulate IP
packets.
Use undo encapsulation-mode to restore the default.
Syntax
encapsulation-mode { transport | tunnel }
undo encapsulation-mode
Default
A security protocol encapsulates IP packets in tunnel mode.
Views
IPsec transform set view
Default command level
2: System level
Parameters
transport: Uses transport mode.
tunnel: Uses tunnel mode.
Usage guidelines
IPsec for IPv6 routing protocols supports only the transport mode.
Examples
# When IPsec uses IKE, configure IPsec transform set tran1 to use the transport encapsulation mode.
<Sysname> system-view
[Sysname] ipsec transform-set tran1
[Sysname-ipsec-transform-set-tran1] encapsulation-mode transport