F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module

101

102

103

104

105

106

107

108

109

110

# Configure the IPv6 address of interface GigabitEthernet 0/1.

[FirewallC] interface gigabitethernet 0/1

[FirewallC-GigabitEthernet0/1] ipv6 address 1::3 64

# Apply address pool 1 to the interface.

[FirewallC-GigabitEthernet0/1] ipv6 dhcp server apply pool 1

394BVerifying the configuration

Display the status of the tunnel interfaces on Firewall A and Firewall B:

[FirewallA] display interface tunnel 1

Tunnel1 current state: UP

Line protocol current state: UP

Description: Tunnel1 Interface

The Maximum Transmit Unit is 1460

Internet Address is 30.1.2.1/24 Primary

Encapsulation is TUNNEL, service-loopback-group ID not set.

Tunnel source 1::1 (GigabitEthernet0/2)

Tunnel bandwidth 64 (kbps)

Tunnel protocol/transport IP/IPv6 dslite-cpe

Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0

Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0

Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0

Last clearing of counters: Never

Last 300 seconds input: 0 bytes/sec, 0 packets/sec

Last 300 seconds output: 0 bytes/sec, 0 packets/sec

9 packets input, 540 bytes

0 input error

9 packets output, 540 bytes

0 output error

[FirewallB] display interface tunnel 2

Tunnel2 current state: UP

Line protocol current state: UP

Description: Tunnel2 Interface

The Maximum Transmit Unit is 1460

Internet Address is 30.1.2.2/24 Primary