F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

232
NOTE:
You cannot add an L2TP whose VT interface already exists. To add it, first delete the corresponding VT
interface from Device Management > Interface Management.
To add an L2TP group:
1. Select VPN > L2TP > L2TP Config from the navigation tree to enter the L2TP configuration page, as
shown in
833HFigure 157.
2. Click Add on the L2TP configuration page to add an L2TP group.
Figure 158 Adding an L2TP group
3. Configure L2TP group information, as described in 834HTable 22.
4. Click Apply.
Table 22 Configuration items
Item Descri
p
tion
L2TP Group Name Specify the name of the L2TP group.
Peer Tunnel Name
Specify the peer name of the tunnel.
When receiving a tunneling request, an LNS determines whether to grant the
tunneling request by checking whether the tunnel name of the LAC matches the
one configured.
Local Tunnel Name
Specify the local name of the tunnel.
By default, the system name of the device is used.