F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

238
Figure 160 Adding an address pool
2. Specify an address pool for assigning IP addresses to PPP users, as described in 840HTable 24.
3. Click Apply.
Table 24 Configuration items
Item Descri
p
tion
ISP Domain
Select the ISP domain for the IP address pool to be created.
If no ISP domain is specified, the address pool is used to allocate IP addresses to
PPP users that do not need authentication.
IP Address Pool Number
Specify the number of the IP address pool.
If you set the IP address pool number to 1, the name of the IP address pool is pool1.
Start IP
Specify the start IP address and end IP address of the IP address pool.
The number of addresses between the start IP address and end IP address must not
exceed 1024. If you specify only the start IP address, the IP address pool will
contain only one IP address—the start IP address.
End IP
229BDisplaying L2TP tunnel information
Select VPN > L2TP > Tunnel Info from the navigation tree to enter the L2TP tunnel information page, as
shown in
841HFigure 161. 842HTable 25 describes the fields on the page.
Figure 161 L2TP tunnel information
Table 25 L2TP tunnel information
Item Descri
p
tion
Local Tunnel ID Local ID of the tunnel.