F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

334
Figure 223 Remote access service resource list
b. Click Add to enter the page for adding a remote access service.
Figure 224 Adding a remote access service
c. Configure the remote access service as described in 948HTable 34.
d. Click Apply.
Table 34 Configuration items
Item Descri
p
tion
Resource Name
Enter a name for the remote access service resource.
The resource name must be unique in the SSL VPN system. Resources are uniquely
identified by their names.
IMPORTANT:
If you do not configure the command for Command, HP recommends including the
resource type, local address, and local port in the resource name so that users can view
the desired information after they log in to the SSL VPN system.
A resource name cannot contain question marks (?), angle brackets (< >), backward
slashes (\), quotation marks (single or double) (' "), percent signs (%), ampersand signs
(&), or pound signs (#).
Remote Host
Specify the host name or IP address of the remote host that provides the remote access
service.
Remote Port Specify the port number that the remote host uses for the remote access service.
Local Host Specify a loopback address or a character string that represents a loopback address.
Local Port
Specify the port number that the local host uses for the remote access service. HP
recommends using a port number greater than 1024 that is rarely used.