F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

30
Figure 24 Network diagram
345BConfiguring Firewall A
1. Configure an IPv4 address for each interface and assign the interfaces to security zones. (Details
not shown.)
2. Create a P2MP GRE tunnel interface:
a. Select VPN > GRE > P2MP from the navigation tree.
b. Click Add.
c. Enter 0 in the Tunnel Interface field, and enter IP address/mask 192.168.22.1/24.
d. Select Management from the Zone list. (Select a security zone according to your network
configuration.)
e. Select GigabitEthernet0/1 as the tunnel source interface.
f. Enter 24 as the branch network address mask, and 10 as the tunnel entry aging time.
g. Click Apply.
Figure 25 Adding a P2MP GRE tunnel interface
3. Configure a static route from Firewall A through interface Tunnel0 to the branch network:
a. Select Network > Routing Management > Static Routing from the navigation tree.