F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

395
75B
AFT configuration task list
287BWhen communication is initiated by an IPv6 host
Task Remarks
1020H
Enabling AFT Required.
1021H
Configuring a DNS64 prefix Required.
1022H
Configuring an IVI prefix
Required.
Perform either one.
1023H
Configuring a 6to4 AFT policy
288BWhen communication is initiated by an IPv4 host
Task Remarks
1024H
Enabling AFT Required.
1025H
Configuring a DNS64 prefix Required.
1026H
Configuring an IVI prefix Required.
1027H
Configuring 4to6 AFT policies Required.
76B
Configuration prerequisites
Before you configure AFT:
1. Enable IPv6 on the AFT. For more information, see Network Management Configuration Guide.
2. Configure an IPv4 or IPv6 address as required on the interface which connects to an IPv4 or IPv6
network and on which AFT is to be enabled.
77B
Enabling AFT
Enable AFT on both the interface connected to the IPv4 network and the interface connected to the IPv6
network.
Do not configure AFT policies and NAT-PT mapping policies on the same device.
To enable AFT:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable AFT on the interface.
aft enable
Disabled by default.
This command enables both AFT and
NAT-PT. For more information about
NAT-PT, see "Configuring NAT-PT."