F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

459
Task Remarks
1077H
Specifying the primary VAM server Required.
Specify a primary VAM server, a
secondary VAM server, or both.
1078H
Specifying the secondary VAM server
1079H
Configuring the username and password Optional.
1080H
Specifying the VPN domain of the VAM client Required.
1081H
Configuring the pre-shared key of the VAM client Required.
1082H
Enabling VAM client Required.
636BCreating a VAM client
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Create a VAM client and
enter its view.
vam client name client-name No client is created by default.
637BSetting the VAM protocol packet retransmission interval
If a client sends a VAM protocol packet to the server but receives no response in a specific period of time,
it retransmits the packet. A VAM protocol packet can be a connection request, negotiation
acknowledgement, registration request, or authentication request.
The maximum number of attempts to retransmit a VAM protocol packet is always 3. You cannot change
this value.
To set the interval for retransmitting a VAM protocol packet:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VAM client view.
vam client name client-name N/A
3. Set the VAM protocol packet
retransmission interval.
resend interval time-interval
Optional.
5 seconds by default.
638BSpecifying the primary VAM server
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter VAM client view.
vam client name client-name N/A
3. Specify the primary VAM
server.
server primary ip-address
ip-address [ port port-number ]
Not specified by default.