F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices VPN Configuration Guide-6PW100

69
• RFC 3056, Connection of IPv6 Domains via IPv4 Clouds
• RFC 4214, Intra-Site Automatic Tunnel Addressing Protocol (ISATAP)
23B
Tunneling configuration task list
Task Remarks
703H
Configuring a tunnel interface N/A
Configuring an
IPv6 over IPv4
tunnel
704H
Configuring an IPv6 manual tunnel
Optional.
Use one as needed.
705H
Configuring an automatic IPv4-compatible IPv6 tunnel
706H
Configuring a 6to4 tunnel
707H
Configuring an ISATAP tunnel
708H
Configuring an IPv4 over IPv4 tunnel Optional.
709H
Configuring an IPv4 over IPv6 manual
tunnel
710H
Configuring an IPv4 over IPv6 manual
tunnel
Optional.
711H
Configuring a DS-lite tunnel
712H
Configuring an IPv6 over IPv6 tunnel Optional.
24B
Configuring a tunnel interface
127BConfiguration prerequisites
Configure a Layer 3 virtual tunnel interface on each device on a tunnel so that devices at both ends can
send, identify, and process packets from the tunnel.
128BConfiguration guidelines
The tunnel bandwidth command sets a bandwidth value for dynamical routing protocols to calculate the
cost of the tunnel and does not affect the actual interface bandwidth. You can determine the value
according to the bandwidth of the actual output interface.
129BConfiguration procedure
To configure a tunnel interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a tunnel interface and
enter its view.
interface tunnel number
By default, no tunnel interface is
created.
3. Configure a description for the
interface.
description text
Optional.
By default, the description of a
tunnel interface is Tunnel number
Interface.