HP A6600 SSL VPN Card Manual-6P102

Manual Version: 6P102-20111130 BOM:

3123A0F6

Part number: 5998-2240

Table 2 SPE-SSL-200 specifications

Item S

ecification

Interface

One console port

Two USB interfaces (reserved)

Interface transmission speed Console port: 9600 bps to 115200 bps (default: 9600 bps)

Cable and maximum

transmission distance

Console port: Asynchronous serial cable with maximum transmission distance

of 15 m (49.21 ft)

CF card and slot

• One CF card slot. By default, no CF card is configured. You can purchase

a CF card as needed.

• The CF card slot supports an external CF card of 256 MB, 512 MB, or 1 GB.

Applied to HP A6604, A6608, and A6616

3 Installing and removing the SPE-SSL-200

ARNING!

• Wear an ESD-preventive wrist strap and ESD-preventive gloves before installing or removing the

module, and make sure that the ESD-preventive wrist strap is properly grounded.

• Avoid touching any components on the PCB and hold the PCB by its edge when installing and removin

the module.

NOTE:

The SPE-SSL-200 is hot swappable. That is, you can remove the module from a router when the router is

powered on.

3.1

Installing the SPE-SSL-200

1. Locate the slot where you will install the SPE-SSL-200, and remove the blank panel from the

position. This manual describes installing the SPE-SSL-200 to slot 2.

2. Push the module (with the components facing on) into the slot along the guide rails until the

positioning hole of the module is seated onto the positioning pin on the backplane. Push the ejector

levers inward to lock the module in place.

3. Fasten the captive screws on the module with a Philips screwdriver.