HP A6600 SSL VPN Card Manual-6P102

Manual Version: 6P102-20111130 BOM: 3123A0F6 Part number: 5998-2240
iii
Figure 3 Insert the SPE-SSL-200
(1) Push the module into the slot along the guide rails until the positioning hole of the module is seated onto the
positionin
g
pin on the backplane.
(2) Push the ejector levers inward to lock the module in place.
3.2 Removing the SPE-SSL-200
1. Loosen the captive screws on the module with a Philips screwdriver until all spring pressure is
released.
2. Hold the ejector levers of the module and push them outward. Gently pull the module out of the slot
along the guide rails.
3. Put the removed module on an antistatic workbench with the PCB side facing upward or place it
in an antistatic bag. If you do not install a new SPE-SSL-200 in the slot, install a blank panel to
prevent dust from entering the chassis and ensure normal ventilation in the router.
4 Logging in to the SPE-SSL-200
Before accessing the SSL VPN Web management interface, you need to access the SSL VPN command
line interface (CLI) through the console port of the SSL VPN module and complete some basic
configurations. The following gives the detailed procedures:
1. Connect your PC to the SSL VPN module
As shown in Figure 4,
use a console cable to connect a serial port of your PC to the console port of the
SSL VPN module.
Figure 4 Access the module by the console port
2. Configure the terminal emulation program on your PC