HP A6600 VPN Firewall Card Manual-6P102

Manual Version: 6P102-20111130 BOM: 3123A0F7 Part number: 5998-2241
v
Table 4 Configure the AUX user interface the SPE-FWM-200
Commands Descri
p
tion
system-view Available in user view.
user-interface aux first-number [ last-number ] Enter one or more AUX user interface views
authentication-mode none
Specify the none authentication mode
By default, password authentication is performed for users
that log in through the AUX user interface.
user privilege level level
Configure the user privilege level for login users
By default, the default command level is 0 for the AUX user
interface. HP recommends you to set the level to 3.
After configuring the AUX user interface, use the oap connect command to log in to the module from the
router to enter the command line interface (CLI) of the module and manage the module. To return to the
CLI of the router, press Ctrl+K.
Table 5 Redirect from the router to the SPE-FWM-200
Command Descri
p
tion
oap connect slot slot-number Available in user view
NOTE:
Besides the login method mentioned in this manual, you can also log in to the SPE-FWM-200 throu
g
h the
w
eb interface, Telnet, or the console port on the module. For more information, see HP High-End Firewall
s
Configuration Guides .
5 Upgrading the SPE-FWM-200
The SPE-FWM-200 supports software upgrade through the console port and a management Ethernet
interface on the module. For more information about how to upgrade the SPE-FWM-200, see HP Security
Modules Software Upgrade Guide.
The SPE-FWM-200 adopts independent boot and application programs, so the boot menu is different
from the router. To upgrade the application program of the SPE-FWM-200, use one of the following
ways:
1. Upgrade through the web interface
• Log in to the web interface through the default management Ethernet port of the SPE-FWM-200
(GigabitEthernet0/0 with IP address 192.168.0.1/24) by using the default web login information
(username admin and password admin). After login, select Device Management > Software
Upgrade from the navigation tree to enter the Software Upgrade page. Then perform related
configurations to upgrade the software.
• During the software upgrade process, do not perform any operation on the web interface.
Otherwise, software upgrade may be interrupted.
2. Remote upgrade at the command line interface (CLI)
• Use the FTP/TFTP protocol through the management Ethernet interface of the SPE-FWM-200.
3. Local upgrade through the boot menu
• Use the XMODEM protocol through the console port of the SPE-FWM-200