HP A8800 Load Balancing Card Manual-6P102

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module

Manual Version: 6P102-20111130 BOM:

3123A0FC

Part number: 5998-2246

HP A8800 Load Balancing Module

1 Appearance

The silkscreen IM-LB is printed at the upper right corner of the front panel, and it identifies the module.

Figure 1 Appearance of the IM-LB

2 Specifications

The IM-LB module provides one console port, one CF card slot, two USB interfaces, two

10/100/1000BASE-T management Ethernet copper interfaces, and two management Gigabit combo

interfaces.

Figure 2 Front panel of the IM-LB

(1) CF card eject button (2)

CF card

slot

(CF CARD)

(3)

CF LED (CFS)

(4) Console port (CONSOLE) (5)

USB interface

(reserved)

(6)

USB interface 2 (reserved)

(7) Management Ethernet interface

1 (10/100/1000BASE-T)

(8) Management Ethernet interface 2

(10/100/1000BASE-T)

(9) Management Ethernet

interface 1 LED (LINK)

(10) Management Ethernet

interface 1 LED (

CT)

(11) Management Ethernet interface

LED

(LINK)

(12) Management Ethernet

interface 2 LED (

CT)

(13) Management interface 3

(Electrical port of combo interface

10/100/1000BASE-T)

(14) Management interface 4

(Electrical port of combo interface

10/100/1000BASE-T)

(15) Management interface 3

(Optical port of combo interface

1000BASE-X)

Summary of content (6 pages)

PAGE 1
Manual Version: 6P102-20111130 BOM: 3123A0FC Part number: 5998-2246 HP A8800 Load Balancing Module 1 Appearance The silkscreen IM-LB is printed at the upper right corner of the front panel, and it identifies the module. Figure 1 Appearance of the IM-LB 2 Specifications The IM-LB module provides one console port, one CF card slot, two USB interfaces, two 10/100/1000BASE-T management Ethernet copper interfaces, and two management Gigabit combo interfaces.
PAGE 2
Manual Version: 6P102-20111130 BOM: 3123A0FC Part number: 5998-2246 (16) Management interface 4 (Optical port of combo interface 1000BASE-X) (17) Management interface 3 LED (LINK) (18) Management interface 3 LED (ACT) (19) Management interface 4 LED (LINK) (20) Management interface 4 LED (ACT) (21) Ejector lever (22) Captive screw Table 1 Description of the LEDs on the IM-LB Silkscreen CFS Color Green LINK Green ACT Yellow Status Description Off No CF card is present or the CF card is n
PAGE 3
Manual Version: 6P102-20111130 BOM: 3123A0FC Part number: 5998-2246 Table 3 1000BASE-X SFP interface specifications Item Specification Connector SFP/LC Interface standards 802.3, 802.3u, and 802.3ab Type Short-haul multi-mode (850 nm) Optical interface module Mid-haul single-mode (1310 nm) Optical interface module Long-haul (1310 nm) Optical interface module Long-haul (1550 nm) Optical interface module Extra-long-h aul (1550 nm) Optical interface module Min –9.
PAGE 4
Manual Version: 6P102-20111130 BOM: 3123A0FC Part number: 5998-2246 Figure 3 Insert the IM-LB 2 1 2 (1) Push the IM-LB into the slot along the guide rails until the positioning hole of the module is seated onto the positioning pin on the backplane. (2) Push the ejector levers inward to lock the IM-LB in place. 3.2 Removing the IM-LB 1. Loosen the captive screws on the IM-LB with a Philips screwdriver until all spring pressure is released. 2.
PAGE 5
Manual Version: 6P102-20111130 BOM: 3123A0FC Commands Part number: 5998-2246 Description Specify the none authentication mode authentication-mode none By default, password authentication is performed for users that log in through the AUX user interface. Configure the user privilege level for login users user privilege level level By default, the default command level is 0 for the AUX user interface. HP recommends you to set the level to 3.
PAGE 6
Manual Version: 6P102-20111130 BOM: 3123A0FC Part number: 5998-2246 NOTE: • The IM-LB does not support software upgrade through a main processing unit (MPU) of the router. • Using the XMODEM protocol to upgrade the module is relatively slow. To reduce the upgrade time, HP recommends you to upgrade the module through the FTP/TFTP protocol. • When you upgrade the IM-LB through the management Ethernet interface, make sure the IM-LB and the FTP or TFTP server can reach each other.