HP A8800 SSL VPN Card Manual-6P102

Manual Version: 6P102-20111130 BOM:

3123A0FD

Part number: 5998-2247

Table 2 IM-SSL specifications

Item S

ecification

Interface

One console port

Two USB interfaces (reserved)

Interface transmission speed Console port: 9600 bps to 115200 bps (default: 9600 bps)

Cable and maximum

transmission distance

Console port: Asynchronous serial cable with maximum transmission

distance of 15 meters (49.21 ft)

CF card and slot

One CF card slot, 256 MB by default for the external CF card

256 MB, 512 MB, or 1 GB for an optional external CF card

Applied to HP A8800 routers

3 Installing and removing the IM-SSL

ARNING!

• Wear an ESD-preventive wrist strap and ESD-preventive gloves before installing or removing the

module, and make sure that the ESD-preventive wrist strap is properly grounded.

• Avoid touching any components on the PCB and hold the PCB by its edge when installing and removin

the module.

NOTE:

The IM-SSL is hot swappable. That is, you can remove the module from a router when the router is

powered on.

3.1

Installing the IM-SSL

1. Locate the slot where you will install the IM-SSL, and remove the blank panel from the position. This

manual describes installing the IM-SSL to slot 2.

2. Push the IM-SSL (with the components facing on) into the slot along the guide rails until the

positioning hole of the module is seated onto the positioning pin on the backplane. Push the ejector

levers inward to lock the IM-SSL in place.

3. Fasten the captive screws on the IM-SSL with a Philips screwdriver.