HP A8800 SSL VPN Card Manual-6P102

Manual Version: 6P102-20111130 BOM:

3123A0FD

Part number: 5998-2247

Figure 4 Access the module by the console port

2. Configure the terminal emulation program on your PC

On your PC, run a terminal emulation program, such as Terminal of Windows 3.X and HyperTerminal of

Windows 9X and Windows XP.

Set the terminal communication parameters as follows:

• Baud rate—9600 bps

• Data bits—8

• Parity—none

• Stop bit—1

• Flow control—none

NOTE:

The required values of the terminal communication parameters depend on the device model.

3. Log in to the CLI and perform basic configurations

• Perform IP address and routing configurations.

• Enable the SSL VPN service (enabled by default).

• Enable the Web service (enabled by default).

• Configure the router to ensure that there is a route available from your Web management terminal

to the SSL VPN gateway.

• Save your configurations.

4. Access the Web management interface through HTTPS

• For super administrators and administrators, from the Web management terminal (your PC, for

example), launch the IE browser and type https://IP address of the internal Ethernet interface of

the module:port number/admin in the address bar to enter the SSL VPN management login page,

as shown in Figure 5.

• F

or normal users, from a Web management terminal (your PC, for example), launch the IE browser

and type https://IP address of the internal Ethernet interface of the module:port number in the

address bar to enter the SSL VPN management login page.

• Enter your username and password and click Login to enter the SSL VPN management page.