HP Security Modules Software Upgrade Guide-6PW103

7
Application Upgrade on the Web Interface
Security modules support Web-based network management. The network administrator can conveniently,
visually manage, maintain, and upgrade the modules on the Web interface. Default Web login
information is set for Security modules before delivery and you can use the default information to log in
to the Web interface.
Table 3 Default Web login information for Security modules (I)
Login
information
FW LB
NS
(not su
pp
orted)
SSL VPN
(not su
pp
orted)
Username admin admin — —
Password admin admin — —
Interface
• GiagbitEthernet
0/0 for the FW
module of the
5800 switch
and 6600
router
• GigabitEthernet
0/1 for the
other FW
modules
GigabitEthernet0/1 — —
Interface IP
address
192.168.0.1/24
192.168.0.1/24 — —
NOTE:
• This chapter illustrates how to up
g
rade the software of an LSR1FW2A1 on the 9500. In a similar way,
you can upgrade the software of other Security modules that support software upgrade on the Web
interface.
• The NetStream modules and SSL VPN modules do not support software up
g
rade on the Web interface.
Preparations for Software Upgrade
Before software upgrade on the Web interface, connect a terminal (usually a PC) to an interface (for
example, GigabitEthernet 0/1) on the Security module LSR1FW2A1 and configure a route between
them as follows:
Step1 Install the Security module in the 9500 series in the way you install an LPU and ensure that the switch
works normally. For more information about the installation, see HP 9500 Series Routing Switches
Installation Guide.
Step2 Connect a PC to interface GigabitEthernet 0/1 of the Security module with a crossover Ethernet cable.
Step3 Configure an IP address for the PC and ensure that the PC and the interface are on the same network
segment.