HP VPN Firewall Appliances Network Management Configuration Guide

364
Ste
p
Command Remarks
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable BFD for RIP.
rip bfd enable destination
ip-address
By default, BFD for RIP is disabled.
The rip bfd enable destination command
and the rip bfd enable command are
mutually exclusive and cannot be
configured on a device at the same time.
Configuring bidirectional control detection
This feature only works for RIP neighbors that are directly connected (one hop away from each other).
To configure BFD for RIP (bidirectional control detection):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIP process and
enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
By default, RIP is disabled.
3. Specify a RIP neighbor.
peer ip-address
By default, RIP does not unicast updates
to any peer.
4. Enter interface view.
interface interface-type
interface-number
N/A
5. Enable BFD on the RIP
interface.
rip bfd enable By default, BFD for RIP is disabled.
NOTE:
Because the undo peer command does not remove the neighbor relationship at once, executing the
command cannot bring down the BFD session at once.
Displaying and maintaining RIP
Task Command Remarks
Display RIP current status and
configuration information.
display rip [ process-id | vpn-instance
vpn-instance-name ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display all active routes in RIP
database.
display rip process-id database [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display RIP interface information.
display rip process-id interface
[ interface-type interface-number ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display routing information about
a specified RIP process.
display rip process-id route [ ip-address
{ mask | mask-length } | peer ip-address |
statistics ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.