ProCurve VPN Client and ProCurve Secure Router 7000dl Series - Application Note

E) Type ‘no shutdown’ to activate the interface to pass data.
F) Type ‘exit’ to return to the Global Configuration mode.
3. Configure the T-1 Interface 1/1
A) Type ‘interface t1 1/1’ to enter configuration of the T1 interface on slot 1 port 1
B) Type ‘tdm-group 1 timeslots 1-24’ to map channels 1 through 24 on the T1 to a
TDM group number 1
C) Type ‘no shutdown’ to active the T-1 interface
D) Type ‘exit’ to exit back to the Global Configuration Mode
E) Type ‘interface ppp 1’ to create a PPP interface number 1
F) Type ‘ip address 172.16.1.2 /31’ to assign an IP address to the ppp interface using
a 31 bit subnet mask.
G) Type ‘no shutdown’ to activate the PPP interface.
H) Type ‘exit’ to return back to the Global Configuration Mode the type ‘bind 1 t1 1/1 1
ppp 1’ to create a bind name 1 and bind the t-1 1/1 interface with TDM group
number 1 to the PPP 1 interface.
I) Type ‘exit’ to return to the Enable Mode then type ‘write memory’ to save the
configuration to non-volatile memory.
4. Create a Static Route to the Secure Site Router
A) From the Global Configuration Mode type ‘ip route 10.24.25.0 255.255.255.0 ppp 1’
to create a static route to the internal network on the secure site router and attach it
to the PPP 1 interface.
ProCurve 7000dl series configuration (Secure Site Router)
1. Reset Router to Factory Defaults
A) Open a VT-100 session with the ProCurve Secure Router. Use the HyperTerminal
icon on your desktop with the following settings:
(1) Baud Rate = 9600
(2) Parity = None
(3) Data Bits = 8
(4) Stop Bits = 1
(5) Flow Control = None
B) Press <Enter> on the keyboard and the access prompt should appear. Enter into
Enable Mode by typing ‘enable’ and factory default the ProCurve Secure Router
using the following commands:
C) Enter <n> for ‘no’ when asked if wanting to save system configuration.
D) Enter <y> for ‘yes’ when asked if wanting to reboot system.
E) Re-establish the connection and log back in to the Enable Mode.
2. Configure the Ethernet Interface 0/1
A) Type ‘enable’ to enter the enable mode, the ‘config t’ to enter the Global
Configuration Mode.
ProCurveSR7102dl#
erase startup
-
config
// Erase start
-
up configuration file
ProCurveSR7102dl#
reload // Reload/reboot the router