Quick Start Guide ProCurve Secure Router 7100/7200 IPSec Base Module J9026A

61195892E1-13A, February 2006 Printed in China Copyright 2006 Hewlett-Packard Development Company, LP
Quick Start Guide 5991-4693
ProCurve Secure Router 7100/7200 IPSec Base Module
J9026A
F
EATURES
The ProCurve Secure Router 7100/7200 IPSec Base Module
is designed to be used in the ProCurve Secure Router to
activate software encryption/decryption and security services
for IPSec VPNs. The card activates the following software
security services in the host processor: DES, triple-DES
(3DES), AES, SHA-1, MD5, and random number generation.
The power consumption of the card does not exceed 1 watt.
Inserting the optional ProCurve Secure Router 7100/7200
IPSec Base Module enables additional security-related
software features on the router. With this module installed,
you can create VPN site-to-site connections between routers.
If VPN client connectivity is required, the ProCurve VPN
Client is available for purchase. Any pure IPSec client can
connect to the router; however, VPN clients with proprietary
implementations will not work with the ProCurve Secure
Router 7100/7200 IPSec Base Module. For more information
on the ProCurve VPN Client software, go to
www.procurve.com.
INSTALLATION INSTRUCTIONS
1. Remove the power from the unit.
2. Slide the ProCurve Secure Router 7100/7200 IPSec Base
Module into the Encryption Module slot (located on the
back of the chassis) until the module is firmly seated
against the chassis.
3. Secure the screws at both edges of the module.
4. Restore power to the unit.
5. The configuration options for encryption will now be
available in the graphical user interface and the Secure
Router Operating System command line interface.
Note
For safety information for the routers and all
modules, please refer to the safety and ESD
precautions in the ProCurve Secure Router
Installation Guide included in your router shipment.