R3166-R3206-HP High-End Firewalls Access Control Configuration Guide-6PW101

98
NOTE:
The following assumes that the portal server runs IMC PLAT 5.0-E0101L02 and IMC UAM 5.0-E0101.
# Configure the portal server.
Log in to the IMC management platform and select the Service tab. Then, select Portal Service
Management > Server from the navigation tree to enter the portal server configuration page, as shown
in Figure 71.
• Input the UR
L address of the portal authentication main page, in the format of http://ip:port/portal,
where ip and port are those configured during the IMC UAM installation. Usually, their default
settings are used.
Figure 71 Portal server configuration
# Configure the IP address group.
Select Portal Service Management > IP Group from the navigation tree to enter the portal IP address
group configuration page. Then, click Add to enter the page for adding an IP address group, as shown
in Figure 72.
• Input the nam
e, start IP address, and end IP address of the IP address group. The IP address of Host
must be within this IP address group.