R3166-R3206-HP High-End Firewalls Access Control Configuration Guide-6PW101

167
Log in to the IMC management platform, select the Service tab, and select Access Service > Access
Device from the navigation tree to enter the Access Device List page. Then, click Add to enter the Add
Access Device page and perform the following configurations as shown in Figure 97:
• S
et the shared key for authenticating both authentication and accounting packets to expert
• Specify the ports for authentication and accounting as 1812 and 1813 respectively
• Select Device Management Service as the service type
• Select HP as the access device type
• Select the access device from the device list or manually add the device with the IP address of
10 .1.1. 2
• Click OK to finish the operation.
NOTE:
The IP address of the access device specified above must be the same as the source IP address of the
RADIUS packets sent from the device, which is the IP address of the outbound interface for RADIUS packets
(the default), or the IP address specified with the nas-ip or radius nas-ip command.
Figure 97 Add an access device
# Add a user for device management.
Log in to the IMC management platform, select the User tab, and select Access User View > Device Mgmt
User from the navigation tree to enter the All Access Users page. Then, click Add to enter the Add Device
Management User page and perform the following configurations as shown in Figure 98:
• A
dd a user named hello@bbb and specify the password
• Select Telnet as the service type
• Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after login,
which is 0 by default.
• Specify the IP address range of the hosts to be managed as 10.1.1.0 to 10.1.1.255, and click OK to
finish the operation.
NOTE:
The IP address ran
g
e of the hosts to be mana
g
ed must contain the IP address of the access device added.