R3166-R3206-HP High-End Firewalls Getting Started Guide-6PW101

133
Character Meanin
g
Remarks
\bcharacter2
Matches character1character2.
character1 can be any character
except number, letter or underline,
and \b equals [^A-Za-z0-9_].
For example, “\ba” matches “-a” with “-“ being
character1, and “a” being character2, but it does
not match “2a” or “ba”.
\Bcharacter
Matches a string containing
character, and no space is allowed
before character.
For example, “\Bt” matches “t” in “install”, but not
“t” in “big top”.
character1\w
Matches character1character2.
character2 must be a number, letter,
or underline, and \w equals
[^A-Za-z0-9_].
For example, “v\w” matches “vlan”, with “v” being
character1, and “l” being character2. v\w also
matches “service”, with “i” being character2.
\W Equals \b.
For example, “\Wa” matches “-a”, with “-” being
character1, and “a” being character2, but does not
match “2a” or “ba”.
\
Escape character. If a special
character listed in this table follows
\, the specific meaning of the
character is removed.
For example, “\\” matches a string containing “\”,
“\^” matches a string containing “^”, and “\\b”
matches a string containing “\b”.
Example of filtering output information
1. Example of using the begin keyword
# Display the configuration from the line containing “user-interface” to the last line in the current
configuration (the output information depends on the device model and the current configuration).
<Sysname> display current-configuration | begin user-interface
user-interface con 0
user-interface aux 0
user-interface vty 0 4
authentication-mode none
user privilege level 3
#
return
2. Example of using the exclude keyword
# Display the non-direct routes in the routing table (the output depends on the device model and the
current configuration).
<Sysname> display ip routing-table | exclude Direct
Routing Tables: Public
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 OSPF 10 2 10.1.1.2 Vlan2
3. Example of using the include keyword
# Display the route entries that contain Vlan in the routing table (the output depends on the device model
and the current configuration).
<Sysname> display ip routing-table | include Vlan
Routing Tables: Public