R3166-R3206-HP High-End Firewalls Getting Started Guide-6PW101

135
To do… Use the command… Remarks
Enter system view system-view —
Enter user interface view
user-interface { first-num1
[ last-num1 ] | { aux | console |
vty } first-num2 [ last-num2 ] }
—
Specify the scheme authentication
mode
authentication-mode scheme
Required
By default, the authentication
mode for VTY and AUX users is
password, and no authentication is
needed for console and TTY login
users.
Return to system view quit —
Configure the authentication mode
for SSH users as password
For more information, see System
Management and Maintenance
Configuration Guide.
Required if users use SSH to log in,
and username and password are
needed at authentication
Configure the
user privilege
level by using
AAA
authentication
parameters
Using local
authentication
• Use the local-user command to
create a local user and enter
local user view.
• Use the level keyword in the
authorization-attribute
command to configure the user
privilege level.
User either approach
• For local authentication, if you
do not configure the user
privilege level, the user
privilege level is 0.
• For remote authentication, if
you do not configure the user
privilege level, the user
privilege level depends on the
default configuration of the
authentication server.
Using remote
authentication
(RADIUS,
HWTACACS,
and LDAP
authentications)
Configure the user privilege level
on the authentication server
Example of configuring a user privilege level by using AAA authentication parameters
# You are required to authenticate the users that telnet to the switch through VTY 1, verify their username
and password, and specify the user privilege level as 3.
<Sysname> system-view
[Sysname] user-interface vty 1
[Sysname-ui-vty1] authentication-mode scheme
[Sysname-ui-vty1] quit
[Sysname] local-user test
[Sysname-luser-test] password cipher 12345678
[Sysname-luser-test] service-type telnet
When users telnet to the switch through VTY 1, they need to input username test and password 12345678.
After passing the authentication, the users can only use the commands of level 0. If the users want to use
commands of levels 0, 1, 2 and 3, the following configuration is required:
[Sysname-luser-test] authorization-attribute level 3
Configure the user privilege level under a user interface
• If the authentication mode of a user interface is scheme, and SSH publickey authentication type
(only username is needed for this authentication type) is adopted, the user privilege level of users
logging into the user interface is the user interface level.