R3166-R3206-HP High-End Firewalls Getting Started Guide-6PW101

35
Configuration procedure
Follow these steps to configure the SSH client to log in to the SSH server:
To do… Use the command…
Remarks
Log in to an IPv4 SSH server ssh2 server
Required
server is the IPv4 address or host
name of the server.
Available in user view
Log in to an IPv6 SSH server ssh2 ipv6 server
Required
server is the IPv6 address or host
name of the server.
Available in user view
NOTE:
You can configure other settings for the SSH client to work with the SSH server. For more information, see
System Management and Maintenance Configuration Guide .
Logging in through the AUX port
Introduction
As shown in Figure 24, the console cable used in AUX port login is the same as that in console port login.
For a device that has separate console and AUX ports, you can use both to log in to the device to
facilitate system maintenance.
Figure 24 AUX port login diagram
By default, AUX port login adopts password authentication. To log in through the AUX port, log in to the
device through the console port or another method, configure the password for AUX password
authentication or change the authentication mode, and configure related parameters.
AUX login authentication modes
NOTE:
By default, password authentication is adopted for AUX port login.
The following authentication modes are available for AUX port login: none, password, and scheme.
• none—Requires no username and password at the next login through the AUX port. This mode is
insecure.
• password—Requires password authentication at the next login through the AUX port. Keep your
password.