R3166-R3206-HP High-End Firewalls Getting Started Guide-6PW101

58
To do… Use the command… Remarks
Set the idle-timeout
timer
idle-timeout minutes [ seconds ]
Optional
The default idle-timeout is 10
minutes. The system automatically
terminates the user’s connection if
there is no information interaction
between the device and the user
within the idle-timeout time.
Setting idle-timeout to 0 disables the
timer.
Set the maximum
interval allowed
between off-hook
and dialing
modem timer answer time
Optional
By default, the interval is 60
seconds.
Configure a
modem to operate
in auto-answer
mode
modem auto-answer
Optional
By default, a modem operates in
non-auto answer mode.
Enable modem
call-in/call-out on
the user interface
modem { both | call-in | call-out }
Optional
By default, both modem call-in and
call-out are disabled.
CAUTION:
• The common settings configured for AUX login take effect immediately. If you configure the common
settings after you log in through the AUX port, the current connection may be interrupted, so you should
use another login method. After you configure common settings for AUX login, you need to modify the
settings on the terminal to make them consistent with those on the device.
• The baud rate of the AUX port must be lower than the transmission rate of the modem. Otherwise,
packets may be lost.
Displaying and maintaining CLI login
To do… Use the command… Remarks
Display information about the user
interfaces that are being used
display users Available in any view
Display information about all user
interfaces that the device supports
display users all Available in any view
Display user interface information
display user-interface [ num1 |
{ aux | console | vty } num2 ]
[ summary ]
Available in any view
Display the configuration of the
device when it serves as a Telnet
client
display telnet client configuration Available in any view