R3166-R3206-HP High-End Firewalls High Availability Command Reference-6PW101

1
VRRP configuration commands
NOTE:
• The term
router in this document refers to both routers and Firewall
• At present, the interfaces that VRRP involves can only be Layer 3 Ethernet interfaces, VLAN interfaces,
Layer 3 aggregate interfaces unless otherwise specified.
• VRRP cannot be configured on an interface of an aggregation group.
vrrp mode
Syntax
vrrp mode load-balance
undo vrrp mode
View
System view
Default level
2: System level
Parameters
load-balance: Specifies VRRP to work in load balancing mode.
Description
Use the vrrp mode command to configure the VRRP working mode.
Use the undo vrrp mode command to restore the default.
By default, VRRP works in standard protocol mode.
• When you configure the working mode of VRRP by using this command, IPv4-based VRRP groups
work in the specified mode.
• When VRRP works in load balancing mode, the virtual IP address cannot be the same as the IP
address of any interface in the VRRP group, and the virtual IP address should be mapped to the
virtual MAC address. Otherwise, VRRP cannot work in load balancing mode.
• When a VRRP group is created, you can still change the VRRP working mode. When you change
the VRRP working mode, all VRRP groups on the router work in the specified mode.
Related commands: display vrrp and display vrrp ipv6.
Examples
# Configure VRRP to work in load balancing mode.
<Sysname> system-view
[Sysname] vrrp mode load-balance