R3166-R3206-HP High-End Firewalls High Availability Command Reference-6PW101

2
display vrrp
Syntax
display vrrp [ verbose ] [ interface interface-type interface-number [ vrid virtual-router-id ] ]
View
Any view
Default level
1: Monitor level
Parameters
verbose: Displays detailed state information of VRRP group(s).
interface interface-type interface-number: Displays VRRP group state information of the specified
interface. interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group. virtual-router-id specifies a
VRRP group by its group number, which ranges from 1 to 255.
Description
Use the display vrrp command to display the state information of VRRP group(s).
If you do not specify verbose, only the brief state information of VRRP group is displayed.
If you specify both an interface and a VRRP group, only the state information of the specified VRRP group
on the interface is displayed. If you only specify an interface, the state information of all the VRRP groups
on the interface is displayed. If you specify neither, the state information of all the VRRP groups on the
router is displayed.
Examples
# When VRRP works in standard protocol mode, display brief information about all VRRP groups on the
device.
<Sysname> display vrrp
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface VRID State Run Adver Auth Virtual
Pri Timer Type IP
---------------------------------------------------------------------
Geth0/1 1 Master 140 1 Simple 1.1.1.1
Table 1 Output description (standard protocol mode)
Field Descri
p
tion
Run Mode
Current VRRP working mode, including:
• Standard: Standard protocol mode
• Load Balance: Load balancing mode