R3166-R3206-HP High-End Firewalls High Availability Command Reference-6PW101

81
Parameters
interface-number: Layer 3 aggregate interface number.
interface-number.subnumber: Sub-interface of a Layer 3 aggregate interface. The interface-number
argument specifies the main interface number. The subnumber argument specifies the subinterface
number and is separated from the main interface number by a dot (.).
Description
Use the interface route-aggregation command to create a Layer 3 aggregate interface/subinterface and
enter the Layer 3 aggregate interface/subinterface view.
Use the undo interface route-aggregation command to remove a Layer 3 aggregate
interface/subinterface.
Upon creation of a Layer 3 aggregate interface, a Layer 3 aggregation group numbered the same is
created automatically. Removing the Layer 3 aggregate interface also removes the Layer 3 aggregation
group. At the same time, the member ports of the aggregation group, if any, leave the aggregation
group.
Note that removing a Layer 3 aggregate subinterface does not affect the state of the main interface and
the corresponding aggregation group.
Examples
# Create Layer 3 aggregate interface Route-Aggregation 1 and enter its view.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1]
lacp system-priority
Syntax
lacp system-priority system-priority
undo lacp system-priority
View
System view
Default Level
2: System level
Parameters
system-priority: LACP priority of the local system, in the range of 0 to 65535. The smaller this value, the
higher the system LACP priority.
Description
Use the lacp system-priority command to set the LACP priority of the local system.
Use the undo lacp system-priority command to restore the default.
By default, the system LACP priority is 32768.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view