R3166-R3206-HP High-End Firewalls High Availability Command Reference-6PW101

82
[Sysname] lacp system-priority 64
link-aggregation load-sharing mode
Syntax
link-aggregation load-sharing mode { destination-ip | destination-port | ip-protocol | source-ip |
source-port } *
undo link-aggregation load-sharing mode
View
System view, Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default Level
2: System level
Parameters
destination-ip: Specifies to perform load sharing in link aggregation groups based on destination IP
address.
destination-port: Specifies to perform load sharing in link aggregation groups based on destination
port.
ip-protocol: Specifies to perform load sharing in link aggregation groups based on IP protocol type.
source-ip: Specifies to perform load sharing in link aggregation groups based on source IP address.
source-port: Specifies to perform load sharing in link aggregation groups based on source port.
Description
Use the link-aggregation load-sharing mode command to configure the global or group-specific
link-aggregation load sharing criterion or criteria.
Use the undo link-aggregation load-sharing mode command to restore the default.
Note that:
• The load sharing criterion or criteria you configured overwrite the old ones, if any.
• In case an unsupported load sharing criterion is configured, you will be prompted of the error.
Examples
# Configure the destination IP address as the global link-aggregation load sharing criterion.
<Sysname> system-view
[Sysname] link-aggregation load-sharing mode destination-ip
# Configure the destination IP address as the load sharing criterion specific to the link aggregation group
of the Bridge-Aggregation 1 interface.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation load-sharing mode destination-ip
link-aggregation mode
Syntax
link-aggregation mode dynamic