R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

102
Selecting a reference port
The system selects a reference port from the member ports that are in the up state and have the same
class-two configurations as the aggregate interface.
The candidate ports are sorted by aggregation priority, duplex and speed in this order: lowest
aggregation priority, full duplex/high speed, full duplex/low speed, half duplex/high speed, and half
duplex/low speed. The one at the top is selected as the reference port. If two ports have the same
aggregation priority, duplex mode and speed, the one with the lower port number wins out.
Setting the aggregation state of each member port
After selecting the reference port, the static aggregation group sets the aggregation state of each
member port as shown in Figure 42.
Figure 42 Set the aggr
egation state of a member port in a static aggregation group