R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

107
To do... Use the command... Remarks
Exit to system view quit —
Enter Layer 3 Ethernet interface
view
interface interface-type
interface-number
Required
Repeat these two steps to assign
multiple Layer 3 Ethernet interfaces
to the aggregation group.
Assign the Ethernet interface to the
aggregation group
port link-aggregation group
number
Configuring a Dynamic Aggregation Group
NOTE:
To
g
uarantee a successful dynamic a
gg
re
g
ation, ensure that the peer ports of the ports a
gg
re
g
ated at one
end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port
Configuring a Layer 2 dynamic aggregation group
Follow these steps to configure a Layer 2 dynamic aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Set the system LACP priority lacp system-priority system-priority
Optional
By default, the system LACP priority
is 32768.
Changing the system LACP priority
may affect the aggregation state of
the ports in a dynamic aggregation
group.
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Configure the aggregation group
to work in dynamic aggregation
mode
link-aggregation mode dynamic
Required
By default, an aggregation group
works in static aggregation mode.
Exit to system view quit —
Enter Layer 2 Ethernet interface
view
interface interface-type
interface-number
Required
Repeat these two steps to assign
multiple Layer 2 Ethernet interfaces
to the aggregation group.
Assign the Ethernet interface to the
aggregation group
port link-aggregation group
number