R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

108
To do... Use the command... Remarks
Assign the port an aggregation
priority
link-aggregation port-priority
port-priority
Optional
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the dynamic aggregation group.
Set the LACP timeout interval on the
port to the short timeout interval (1
second)
lacp period short
Optional
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).
Configuring a Layer 3 dynamic aggregation group
NOTE:
Support for this feature depends on your device model.
Follow these steps to configure a Layer 3 dynamic aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Set the system LACP priority lacp system-priority system-priority
Optional
By default, the system LACP priority
is 32768.
Changing the system LACP priority
may affect the aggregation state of
the ports in the dynamic
aggregation group.
Create a Layer 3 aggregate
interface and enter the Layer 3
aggregate interface view
interface route-aggregation
interface-number
Required
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
Configure the aggregation group
to work in dynamic aggregation
mode
link-aggregation mode dynamic
Required
By default, an aggregation group
works in static aggregation mode.
Exit to system view quit —
Enter Layer 3 Ethernet interface
view
interface interface-type
interface-number
Required
Repeat these two steps to assign
multiple Layer 3 Ethernet interfaces
to the aggregation group.
Assign the Ethernet interface to the
aggregation group
port link-aggregation group
number