R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

109
To do... Use the command... Remarks
Assign the port a LACP priority lacp port-priority port-priority
Optional
By default, the LACP priority of a
port is 32768.
Changing the LACP priority of a
port may affect the aggregation
state of ports in the dynamic
aggregation group.
Configuring an Aggregate Interface
You can perform the following configurations on an aggregate interface:
• Configuring the Description of an A
ggregate Interface/Subinterface
• Configuring the MTU of a Layer 3 Aggregate Interface/Subinterface
• Enabling Link State Trapping for an Aggregate Interface
• Configuring the Minimum and Maximum Number of Selected Ports in an Aggregation Group
• Shutting Down an Aggregate Interface
NOTE:
In addition to the confi
g
urations listed above, most of the confi
g
urations that can be performed on Layer
2 or Layer 3 Ethernet interfaces can also be performed on Layer 2 or Layer 3 aggregate interfaces. For
details, see related configuration guides.
Configuring the Description of an Aggregate
Interface/Subinterface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
Follow these steps to configure the description of an aggregate interface/subinterface:
To do... Use the command... Remarks
Enter system view system-view —
Enter
aggregate
interface
view
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Use either command.
Enter Layer 3
aggregate
interface/subint
erface view
interface route-aggregation
{ interface-number |
interface-number.subnumber }
Configure the description of the
aggregate
interface/subinterface
description text
Optional
By default, the description of an
interface is interface-name Interface,
such as Bridge-Aggregation1
Interface.