R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

112
NOTE:
• When confi
g
urin
g
this feature in a static link a
gg
re
g
ation
g
roup, make sure that you confi
g
ure the same
settings on the aggregation group at the other end of the aggregate link.
• Configuring the minimum number of selected ports required to bring up an aggregation group may
cause all the member ports in the current aggregation group to become unselected.
• Configuring the maximum number of selected ports in an aggregation group may cause some of the
selected member ports in the current aggregation group to become unselected.
Shutting Down an Aggregate Interface
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group:
• When an aggregate interface is shut down, all selected ports in the corresponding aggregation
group become unselected and their link state becomes down.
• When an aggregate interface is brought up, the aggregation state of ports in the corresponding
aggregation group is recalculated and their link state becomes up.
Follow these steps to shut down an aggregate interface:
To do... Use the command... Remarks
Enter system view system-view —
Enter
aggregate
interface
view
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Required
Use either command.
Enter Layer 3
aggregate
interface/subinterf
ace view
interface route-aggregation
{ interface-number |
interface-number.subnumber }
Shut down the aggregate
interface/subinterface
shutdown
Required
By default, aggregate
interfaces/subinterfaces are up.
NOTE:
A
s an a
gg
re
g
ate subinterface does not have an associated a
gg
re
g
ation
g
roup, shuttin
g
down an
aggregate subinterface does not affect any aggregation group.
Configuring Load Sharing for Link Aggregation
Groups
Configuring Load Sharing Criteria for Link Aggregation
Groups
You can determine how traffic is load-shared in a link aggregation group by configuring load sharing
criteria. The criteria can be service port numbers, IP addresses carried in packets, or any combination of