R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

114
To do... Use the command... Remarks
Clear LACP statistics for a specific
or all link aggregation member
ports
reset lacp statistics [ interface interface-list ] Available in user view
Clear statistics for a specific or all
aggregate interfaces
reset counters interface
[ { bridge-aggregation | route-aggregation }
[ interface-number ] ]
Available in user view
Ethernet Link Aggregation Configuration Examples
NOTE:
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
the Configuration classes se
ction) as the reference port (see the Reference port section) can operate as
selected ports. Therefore, you must ensure that all member ports have the same port attributes and
class-two configurations as the reference port. The other settings only need to be configured on the
aggregate interface, not on the member ports.
Layer 2 Static Aggregation Configuration Example
Network requirements
As shown in Figure 44:
• Firewall A and Firewall B are connected through their respective Layer 2 Ethernet interfaces
GigabitEthernet 0/1 through GigabitEthernet 0/3.
• Configure a Layer 2 static link aggregation group on Firewall A and Firewall B respectively, enable
VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and
VLAN 20 at one end to communicate with VLAN 20 at the other end.
Figure 44 Network diagram for Layer 2 static aggregation
Configuration procedure
1. Configure Firewall A
# Create VLAN 10, and assign port GigabitEthernet 0/4 to VLAN 10.
<FirewallA> system-view