R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

69
To do… Use the command… Remarks
Configure the destination port of
UDP packets
destination port port-number
Required
By default, no destination port
number is configured.
The destination port must be the
same as that of the listening service
on the NQA server.
Specify the source port number of
UDP packets
source port port-number
Optional
By default, no source port number
is specified.
Configure the size of the data field
in each UDP packet
data-size size
Optional
100 bytes by default.
Configure the string to be filled in
the data field of each probe packet
data-fill string
Optional
By default, the string is the
hexadecimal number
00010203040506070809.
Configure the number of probe
packets to be sent during each UDP
jitter probe operation
probe packet-number
packet-number
Optional
10 by default.
Configure the interval for sending
probe packets during each UDP
jitter probe operation
probe packet-interval
packet-interval
Optional
20 milliseconds by default.
Configure the interval the NQA
client must wait for a response from
the server before it regards the
response is timed out
probe packet-timeout
packet-timeout
Optional
3000 milliseconds by default.
Configure the source IP address for
UDP jitter packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
Configure optional parameters
See “Configuring optional
parameters for an NQA test
group”
Optional
NOTE:
The probe count command specifies the number of probe operations during one UDP jitter test. The probe
packet-number command specifies the number of probe packets sent in each UDP jitter probe operation.
Configuring SNMP tests
SNMP tests of an NQA test group are used to test the time the NQA client takes to send an SNMP packet
to the SNMP agent and receive a response.