R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

71
To do… Use the command… Remarks
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as TCP
and enter test type view
type tcp Required
Configure the destination
address of TCP probe packets
destination ip ip-address
Required
By default, no destination IP address is
configured.
The destination address must be the
same as the IP address of the listening
service configured on the NQA server.
Configure the destination port
of TCP probe packets
destination port port-number
Required
By default, no destination port number
is configured.
The destination port number must be
the same as that of the listening service
on the NQA server.
Configure the source IP
address of TCP probe packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface. The local
interface must be up; otherwise, no
probe packets can be sent out.
Configure optional parameters
See ”Configuring optional
parameters for an NQA test
group”
Optional
Configuring UDP echo tests
UDP echo tests of an NQA test group are used to test the connectivity and round-trip time of a UDP packet
from the client to the specified UDP port on the NQA server.
Configuration prerequisites
UDP echo tests require cooperation between the NQA server and the NQA client. Before you start UDP
echo tests, configure a UDP listening service on the NQA server. For more information about the UDP
listening service configuration, see ”Configuring the NQA server.”
Configuring UDP echo tests
Follow these steps to configure UDP echo tests:
To do… Use the command…
Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as UDP
echo and enter test type view
type udp-echo Required