R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

74
To do… Use the command… Remarks
Specify the source IP address of
probe packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface. The local
interface must be up; otherwise, no
probe packets can be sent out.
Specify the source port number of
probe packets
source port port-number
Optional
By default, no source port number is
specified.
Configure the size of the data field
in each probe packet
data-size size
Optional
By default, the probe packet size
depends on the codec type. The default
packet size is 172 bytes for
G.711A-law and G.711 μ-law codec
type, and is 32 bytes for G.729 A-law
codec type.
Configure the string to be filled in
the data field of each probe packet
data-fill string
Optional
By default, the string is the hexadecimal
number 00010203040506070809.
Configure the number of probe
packets to be sent during each
voice probe operation
probe packet-number
packet-number
Optional
1000 by default.
Configure the interval for sending
probe packets during each voice
probe operation
probe packet-interval
packet-interval
Optional
20 milliseconds by default.
Configure the interval the NQA
client must wait for a response from
the server before it regards the
response times out
probe packet-timeout
packet-timeout
Optional
5000 milliseconds by default.
Configure optional parameters
See ”Configuring optional
parameters for an NQA test
group”
Optional
NOTE:
Only one probe operation is performed in one voice test.
Configuring DLSw tests
DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Configuration prerequisites
Before you start DLSw tests, enable the DLSw function on the peer device.
Configuring DLSw tests
Follow these steps to configure DLSw tests: