R3166-R3206-HP High-End Firewalls High Availability Configuration Guide-6PW101

75
To do… Use the command… Remarks
Enter system view System-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as DLSw
and enter test type view
type dlsw Required
Configure the destination address
of probe packets
destination ip ip-address
Required
By default, no destination IP address
is configured.
Configure the source IP address of
probe packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface. The local
interface must be up; otherwise, no
probe packets can be sent out.
Configure optional parameters
See ”Configuring optional
parameters for an NQA test
group”
Optional
Configuring the collaboration function
Collaboration is implemented by establishing reaction entries to monitor the detection results of a test
group. If the number of consecutive probe failures reaches the threshold, the configured action is
triggered.
Follow these steps to configure the collaboration function:
To do… Use the command…
Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Enter test type view of the test
group
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo }
The collaboration function is not
supported in UDP jitter and voice
tests.
Create a reaction entry
reaction item-num checked-element
probe-fail threshold-type
consecutive occurrences
[ action-type { none |
trigger-only } ]
Required
Not created by default.
You cannot modify the content of
an existing reaction entry.
Exit to system view quit —
Create a track entry and associate
it with the reaction entry of the
NQA test group
track entry-number nqa entry
admin-name operation-tag
reaction item-num
Required
Not created by default.